Start and link to regularity zone

To draw the start of the rally at the beginning of TC1, we have a video tutorial below, where we follow the following steps:

1. Stop at the Start.
2. Reset odometer to zero.
3. Add and draw the start reference.
4. Drive and make a quick stop at each of the references when adding the reference to take the exact measurement.
5. There is no need to stand while drawing, if you have a co-pilot and with a little experience you can continue while the co-pilot is drawing the bullets.
6. At the end of the link add the last bullet that will be the same one from the beginning of the timed section.

Now we have the initial link ready, the next phase is to draw a Timed Stage and put the control points (PCs).